Quantum 10K II - Manual (Page 86)

SCSI Description
Quantum Atlas 10K II Ultra160/m SCSI Hard Disk Drives 5–19
Table 5–5 DATA-Phase Command Contents (continued)
Length Data Out Data In
Command in CDB (To Drive) (To Initiator)
SEEK (6)(10) 0 --- ---
SEND DIAGNOSTIC Parameter List Diagnostic Page ---
SET DEVICE IDENTIFIER
START STOP UNIT
0 --- ---
SYNCHRONIZE 0 --- ---
CACHE
TEST UNIT READY
0 --- ---
VERIFY Transfer Data ---
WRITE (6)(10) Transfer Data ---
WRITE AND VERIFY Transfer Data ---
WRITE BUFFER Parameter List Zeros (4) ---
Mode-zero buffer (512)
or Data to put into DRAM
or Microcode image (262,144)
or Microcode image
(successive 16 KB pieces)
WRITE LONG Byte Transfer • Data (512) ---
(must be 560) • LBA Tag (2)
• EDC (2)
• ECC (44)
WRITE SAME 0 Data (1 logical sector) ---
WRITE SKIP MASK
XDREAD
XDWRITE
XPWRITE