Quantum 10K II - Manual (Page 28)

Quantum Atlas 10K II Ultra 160/m SCSI Hard Disk Drives 3 − 1
Chapter 3
INSTALLATION
This chapter explains how to unpack, configure, mount, and connect the Quantum
Atlas 10K II Ultra 160/m SCSI hard disk drive prior to operation.
3.1 SAFETY, HANDLING, & ELECTROSTATIC DISCHARGE PROTECTION
3.1.1 Safety Precautions
For your safety, follow all safety procedures described here and in other sections of
the manual.
•
Remove power from the computer system (or expansion unit) before installing or
removing the drive to prevent the possibility of electrical shock or damage to the
drive. Unplug the unit containing the drive to provide an added measure of
safety.
• Read, understand, and observe all label warnings.
3.1.2 Handling
Damage to the drive can occur as the result of careless handling, vibration, shock,
or electrostatic discharge (ESD). Always handle the drive with care to avoid damage
to the precision internal components.
CAUTION
A 1/4-inch drop onto a hard surface can damage the drive
Follow these guidelines to avoid damage to the drive:
•
Always observe prescribed ESD precautions.
• Keep the drive in its anti-static bag until ready to install.
• Always use a properly fitted wrist strap or other suitable ESD protection when
handling the drive.
• Hold drive only by its sides. Do not touch any components on the PCBA.
• Always handle the drive carefully and gently. A drop of 1/4 inch onto a bench or
desktop can damage a drive.
• Do not bump, jar, or drop the drive. Use care when transporting the drive.
• Always gently place the drive flat, PCB side down, on an appropriate ESD-
protected work surface to avoid the drive being accidentally knocked over.
• Do not pack other materials with the drive in its shielded bag.
• Place the drive in the anti-static bag before placing in shipping container.
• Do not stack objects on the drive.