Warning, Cb1200-i pellet insert, B. clearance to combustibles, ul and ulc – Quadra-Fire PELLET INSERT CB1200MI-MBK User Manual

Page 9: As a built-in

Advertising
background image

R

R

R

February 3, 2010

7014-188B

Page 9

CB1200-I Pellet Insert

NOTE:

Illustrations reflect typical installations and

are FOR DESIGN PURPOSES ONLY.

Illustrations/diagrams are not drawn to

scale.

Actual installation may vary due to

individual design preference.

B. Clearance To Combustibles, UL and ULC

12 in.

(305mm)

Rear Shroud

6 in.

(152mm)

Shown with Hopper Extended

Optional Outside
Air

Combustible
Mantel

INSTALLED AS A BUILT-IN UNIT

Shown with Rear Vent and Optional Outside Air

Figure 9.1

Figure 9.2

AS A BUILT-IN

B

D

C

E

B

C

A

0 INCH (0mm) CLEARANCE TO ExPOSED SECTION AND FACE TRIM

Rear Shroud Kit is Required for Built-In Installation

A

Top of Shroud

Top Vent

3.0

76

Rear Vent

0

0

B

Sides of Inside Shroud

Top or Rear Vent

0

0

C

Back of Inside Shroud

Top Vent

2.5

64

Rear Vent

0

0

D

Vent Pipe to Combustible

Top or Rear Vent

3.0

76

Fire Risk.

WARNING

Failure to comply may cause house fire.

Comply with all minimum clear-

ances to combustibles as specified.

NOTICE:
Please note that while the minimum clear-

ance for the termination cap is 6 inches

(152mm) there is the possibly of soot

buildup around the termination area. If this

occurs we suggest to move the termination

further away from the house to prevent it.

Advertising
This manual is related to the following products: