Toshiba Stratagy IVP8 - Manual (Page 13)

Stratagy IVP8 Installation Guide 01/02
1
The Grand Tour
1
The Stratagy IVP8 voice processing circuit card
(shown at right) supports up to eight ports, and installs
in selected card slots of a Strata CTX or Strata DK
Base or Expansion Cabinet/Key Service Unit (KSU).
Each Stratagy IVP8 has been preprogrammed at the
factory for out-of-box (plug-and-play) operation on
the Strata CTX. This includes the KSU integration and
configuration parameters, default station (extension
number) User ID mailboxes, and company greeting
and instructions.
The supported systems and recommended software
versions are:
• Strata CTX100/CTX670 — all releases
• Strata DK40i/DK40/DK16e/DK16 — all releases
• Strata DK424i/DK424/DK280 — all releases
• Strata DK24/DK56/DK96 — Release 4
The Stratagy IVP8 requires Stratagy Admin software, installed on a separate IBM-compatible
Stratagy Admin PC, for local or remote administration and maintenance.
Voice mail integration is provided by Strata CTX or Strata DK in-band (DTMF) integration.
Strata CTX, DK424i, DK424 and DK280 can also provide integration using the Simplified
Message Desk Interface (SMDI) output of the BSIS, PIOU, PIOUS, RSSU, RSIU, or RSIS SMDI
port.
Hardware
The Stratagy IVP8 consists of a flash drive with approximately four hours of storage, an internal
modem, a status light, and eight voice ports with corresponding voice port status lights (see
Figure
1 ).
The Stratagy IVP8’s two serial ports are allocated as follows: Serial Port 1 is reserved for SMDI
and Port 2 for the Stratagy Admin PC connection.
6036