Toshiba Stratagy IVP8 - Manual (Page 31)

Installation
Step 9: Configure Stratagy Admin Software
Stratagy IVP8 Installation Guide 01/02
19
Table 2 Stratagy Admin PC Configuration Fields
Field Description/Default
Advertising
Advertising string that displays when the Main Menu screen blanks after a specified number of
minutes of inactivity (per tmo_blank parameter in the install.cfg file).
Possible values: 60-character string. The single quotes are required.
Default: ‘Stratagy ADMIN’
Log File
System log file name. This log file contains connection information, any execution error information,
and file copy actions.
Note It is a good idea to periodically archive or delete this file once or twice a year, whenever
you perform preventive maintenance.
Possible values: Eight-character file name, plus three-character extension. The single quotes are
required.
Default: ‘Remote.LOG’
Serial Port
Port number
Possible values: 1~2
Default: 2
Baud Rate
Baud rate of serial port.
Possible values: 1200, 2400, 9600
Default: 9600
Modem Init
String
Sets modem initialization string. The modem initialization string can be changed to work with
specific brand modems. Refer to the user’s manual for your individual modem for the initialization
string.
Note The protocol used by Stratagy Admin does not support error correction, data compression,
or auto baud rate adjustment. If problems are encountered connecting remotely, turn
these parameters off on the Stratagy Admin PC modem. Refer to your modem user guide
for instructions.
Default: AT&F&C1&D2L0Q0V0X0E1
where:
AT The command that tells the modem to come to Attention.
&F Return to factory defaults.
Instructs the modem to use the factory set parameters.
&C1 Data Carrier Detect (DCD) signal.
Set to on, it indicates presence of a data carrier.
&D2 Data Terminal Ready selected.
L0 Speaker volume.
Off or low volume.
Q0 Mode responses.
Enables result codes to be issued to the screen.
V0 Result code format.
Numeric format.
X0 Extended result codes.
Disables monitoring of busy tones unless forced otherwise by country requirements. Sends
only OK, connect, ring, no carrier, error and no answer result codes.
E0 Command Character Echo.
Disables echoing of the commands to the screen.