Front side connectors (figure 12), Rear side connectors (figure 1-3), Front side connectors (figure 1-2) – Tripp Lite B050-000 User Manual
Page 10
Chapter 1. The Quick Start Guide
Front Side Connectors (Figure 1-2)
Figure 1-2. Front Side Connectors and Indicators
System port
Attach the system cable with the gray connector to this port.
Power/Status LED
Displays the status of the B050-000:
•
LED off: the B050-000 has no or not enough power
•
LED blinking: the B050-000 is booting up (if this process takes longer than one
minute, the reason may be a lack of power).
•
LED on: the B050-000 is up and running.
If the B050-000 is connected via USB only and the Power/Status LED tends not
to stop blinking after one minute, the B050-000 may not receive enough power
via USB. In that case attach the enclosed power supply to the B050-000.
Power supply DC 5V
Attach the enclosed power supply to the B050-000.
•
Voltage: 5V
•
Current: 1.5 A
RJ45 Ethernet
UTP3/5 cables can be connected to the B050-000 using this standard RJ45 jack.
2