Tripp Lite B050-000 - Manual (Page 22)

Chapter 3. Installation
Front Side Connectors and Indicators
Figure 3-2. Front Side Connectors and Indicators
System port
Attach the system cable with the gray connector to this port.
Power/Status LED
Displays the status of the B050-000:
• LED off: the B050-000 has no or not enough power
• LED blinking: the B050-000 is booting up (if this process takes longer than one
minute, the reason may be a lack of power).
• LED on: the B050-000 is up and running.
If the B050-000 is connected via USB only and the Power/Status LED tends not
to stop blinking after one minute, the B050-000 may not receive enough power
via USB. In that case attach the enclosed power supply to the B050-000.
Power supply DC 5V
Attach the enclosed power supply to the B050-000.
• Voltage: 5V
• Current: 1.5 A
RJ45 Ethernet
UTP3/5 cables can be connected to the B050-000 using this standard RJ45 jack.
14