Toshiba Carrier RAV-SP180UT-UL EN - Manual (Page 27)

Toshiba
– 26 –
4-way Air Discharge Cassette Type
Installation Manual
EN
„ Louver lock (No swing)
1. Push (right side of the button) for at least
four seconds when the air conditioner is not working.
flashes.
Indicates CODE No. “F1.”
2. Select an indoor unit to be set by pushing
(left side of the button).
Each time you push the button, unit numbers
change as follows:
The fan of the selected unit runs and the louvers
start swinging.
3. Select a louver you want to lock by pushing TEMP.
buttons.
4. Select the louver direction you do not want to swing
by pushing TIME buttons.
* When (4) or (5) is selected, dew drop may occur
during cooling mode.
5. Determine the setting by pushing button.
When the setting has been determined, lights
up.
6. Push button to complete the setting.
„ Cancel louver lock
Set the louver direction to “0000” of the louver lock
setup procedure above.
• When the setting is canceled, goes out.
Other operations are the same as those in
“Louver lock (No swing)”.
„ Power saving mode
1. Push button for at least four seconds when
the air conditioner is not working.
flashes.
Indicates CODE No. “C2.”
2. Select an indoor unit to be set by pushing
(left side of the button).
Each time you push the button, unit numbers
change as follows:
The fan of the selected unit runs and the louvers
start swinging.
3. Adjust the power save setting by pushing TIME
buttons.
Each push of the button changes the power level by
1% within the range from 100% to 50%.
* The factory default is 75%.
4. Determine the setting by pushing button.
5. Push button to complete the setting.
UNIT No.
1-1
UNIT No.
1-2
UNIT No.
1-3
UNIT No.
1-4
(1)
0001
(2)
0002
(3)
0003
(5)
0005
(4)
0004
Setting data
0001-0005
(Louver lock position code)
0000 Setting data
UNIT No.
1-1
UNIT No.
1-2
UNIT No.
1-3
UNIT No.
1-4
Setting of power level in
power saving mode
26-EN
+00EH99864701_00Ta.book Page 26 Tuesday, November 24, 2009 4:54 PM