Toshiba Carrier RAV-SP180UT-UL EN - Manual (Page 30)

Toshiba
– 29 –
4-way Air Discharge Cassette Type
Installation Manual
Procedure 3
1. Using temp. setup / buttons, specify CODE
No. [12].
(CODE No. [12]: Line address)
2. Using timer time / buttons, change the line
address from [3] to [2].
3. Push button.
In this time, the setup finishes when the display
changes from flashing to lighting.
Procedure 4
1. Using temp. setup / buttons, specify CODE
No. [13].
(CODE No. [13]: Indoor address)
2. Using timer time / buttons, change the indoor
address from [3] to [2].
3. Push button.
In this time, the setup finishes when the display
changes from flashing to lighting.
Procedure 5
1. Using temp. setup / buttons, specify CODE
No. [14].
(CODE No. [14]: Group address)
2. Using timer time / buttons, change the setup
data from [0001] to [0002].
(Setup data [Header unit: 0001] [Follower unit:
0002])
3. Push button.
In this time, the setup finishes when the display
changes from flashing to lighting.
Procedure 6
If there is other indoor unit to be changed, repeat
procedure
2 to 5 to change the setup.
When the above setup has finished, push to
select the indoor UNIT No. before change of setup,
specify CODE No. [12], [13], [14] in order with temp.
setup
/ buttons, and then check the changed
contents.
Address change check Before change:
[3-3-1]
→ After change: [2-2-2]
Pushing button clears the contents of which setup
was changed.
(In this case, procedure from
2 is repeated.)
Indoor UNIT No. before setup change is displayed.
Indoor UNIT No. before setup change is displayed.
Indoor UNIT No. before setup change is displayed.
Indoor UNIT No. before setup change is displayed.
29-EN
+00EH99864701_00Ta.book Page 29 Tuesday, November 24, 2009 4:54 PM