Toshiba Strata CT DKT2510-FSD - Manual (Page 21)

Strata CT Digital Telephone User Guide November 2001
5
The Digital Telephone Grand Tour Buttons
Hold
(continued)
If the held party hangs up, the call is released and the Exchange provides a
hold-release signal.
If your telephone is programmed for Automatic Hold, existing calls are
automatically placed on hold when you answer a call or make another call.
(See
“Automatic Hold” on Page 24 .)
A different call can be held on each [DN] or
Line
button on your phone. Each time you
press
Scroll
, a different [DN] or
Line
is
selected. The selected button’s LED flashes
rapidly and your LCD displays information for
the call holding on that button (samples
shown at right).
Mic
(Microphone)
Press to toggle the microphone ON/OFF while the telephone is in use. The
LED indicates the status of the microphone.
The microphone and accompanying LED are always ON when receiving
“voice first” internal [DN] calls to enable Handsfree Answerback and OFF if
you receive a ring-first call. Mic may be ON/OFF when placing an on-hook
Exchange line or internal [DN] call.
Each station’s Mic can be set in system programming to switch ON/OFF with
one touch, to switch OFF only while pressed and held, or to be either ON/OFF
at the start of handsfree dialling.
To talkback to an HS-OCA call, press and hold Mic and talk over your
telephone handset/headset. The LED and microphone remain OFF during
OCA talkback operation (see
“HS-OCA” on Page 56 ).
Mic functions on Handsfree Answerback and OCA calls for privacy.
Msg
(Message)
When Msg LED flashes, press
Msg
to call back the station or voice mail
device that activated the LED (see “Message Waiting” on Page 51 ). This is the
telephone’s [PDN] message waiting button.
Redial
Press the same [DN] or
Line
that you used to dial the original number. Press
Redial
. The last number called is redialled.
If you have Automatic Line Selection, you must first lift the handset.
Table 1 Fixed Button Definitions (continued)
Button Definitions
CO LINE 02
HOLD
DN 202
HOLD