Toshiba MA-516-100 - Manual (Page 129)

- 125 -
EO1-11116
MA-516-100 SERIES
→
→
Address: 7 initial SET Bit Nos. 1 2 3
([CHK TND] Key Function) Your Selection
Selective Status
RESET SET
1 Tender and Total Functions in finalizing
a sale
2 Validation Print Content on
Over-tendering
3 Cashing with no purchase, using this key.
4 Over-tendering (tendering an amount
larger than the sale total, resulting in
calculation of change due)
5 to 8 -- vacant --
TENDER only
TENDERED AMOUNT
TENDER or TOTAL
SALE TOTAL
PROHIBITED
ALLOWED
ALLOWED
PROHIBITED
Supplementary Description:
Bit 1: RESET status ............... The key functions as Tender Key with a prior amount entry or as Total Key
without any amount entry.
SET status .................... The key always requires a tender amount entry.
Bit 2: RESET status ............... Prints the sale total amount.
SET status .................... Prints the tendered amount.
In case of a short-tender, the tendered amount is always printed regardless of this bit status selection.
Bit 3: RESET status ............... Customers’ checks cannot be cashed outside a sale.
SET status .................... Customers’ checks can be cashed with no purchase outside a sale.
Bit 4: This Bit status selection is effective only in tendering operation.
SET status .................... If this bit is SET and also Address 11 - Bit 1 is SET (for Short-tendering
Prohibited), an amount equal to the sale total is always required for tendering.
Bit No. Content