Toshiba MA-516-100 - Manual (Page 28)

- 24 -
EO1-11116
MA-516-100 SERIES
2) Tax 1; “A” Break and % Rate Combination (Non-cyclic Breaks + % Rate)
First, set all the non-cyclic breaks up to the “A” Break entry and the [ST] key depression shown in the above case
of “1) Tax 1 Full Breaks”.
↓
|Tax Rate applied when exceeding the “A” Break amount|
(Max. 6 digits up to 99.9999%. Use the [ . ] key for a decimal value. Examples: To set 5%, enter 5. To set 5.26%,
enter 5
→
[ . ]
→
2
→
6. The fraction of the amount resulting from this % rate calculation will be rounded off.)
↓
(to complete this tax table setting)
3) Tax 1; % Rate Only
→
(to indicate that no breaks are entered)
|Tax Rate applied to any amount|
→
(The description for the Tax Rate in the above case 2) is also applied to this case.)
NOTES 1. For Tax 2 table setting in a multi-tax area, follow the same procedure in 1), 2), or 3) above,
using the [TX2/M] key instead of [TX1/M].
To install the [TX2/M] key on the keyboard, refer to Chapter “15. Optional Key Setting” on
page 30.
2. If two tax tables are to be set, the Tax 1 table must be set first. The Tax 1 table setting will
automatically reset the old Tax 1 and Tax 2 tables. The Tax 2 table can be set only when the
Tax 1 table has been set (i.e., the Tax 2 table alone cannot be set without setting the Tax
1 table).
3. No second depression of the [ST] key is allowed within one tax table setting. A maximum
of 64 breaks may be entered for Tax 1 and Tax 2 tables altogether.
0
AT/TL
ST
TX1/M
AT/TL