Toshiba MA-516-100 - Manual (Page 43)

- 39 -
EO1-11116
MA-516-100 SERIES
→ →
Clearing Errors, or Clearing Wrong Declaration
Key or Wrong Numeric Entries
When in sale entries an error has occurred with an alarm buzzer (beeps for about 2 seconds only), a wrong Declaration
Key (such as [RTN MDSE], [TX/M], [GST/M], etc.) has been depressed, or a wrong numeric data has been entered;
depress the [C] key.
(Clear Key)
1) Error has occurred (the alarm
buzzer is generated and the
“ALM” lamp illuminates), and
the keyboard is locked.
2) Declaration Key has been de-
pressed.
Example)
3) Numeric Keys are entered.
Example)
4) Declaration Key (s) + Numeric
Keys
Example)
5) Numeric Keys + Non-motorized
Key (key that does not trigger
printing)
Example)
6) Combination of 2) to 5)
7) Combination of 6) + 1)
0 5 0
0 7
2 1
The error condition is cleared (the
buzzer tone stops and the “ALM” lamp
is extinguished). Find the cause of the
error, and do the operation again. Re-
fer to “Possible Cause of Error” at-
tached where an error may occur in
each operation sequence on the fol-
lowing procedure.
The entered data are all cleared at once.
The entered data are all cleared at once,
and the error condition is cleared also.
Refer to 1) for finding the cause of error.
NOTE: When data is already entered and printed (through a Department Key, etc.), it cannot be cleared by the [C]
key any longer. In need of deleting such data, see the following:
Item Correction (Last Line Voiding) page 68
Void (Designated Line Voiding) page 70
All Void (Transaction Cancel) page 71
Operations in “ - ” Mode Chapter 20 (page 98)
→ →
→ →
VOID
ITEM
CORR
ALL
VOID
C
C
C
C
RTN
MDSE
X
RTN
MDSE