Paper roll wrinkles, Printer prints nothing, Printing as a whole is too light – Toshiba MA-516-100 User Manual
Page 155: Printing gets stained, Printing is uneven or too light
- 151 -
EO1-11116
MA-516-100 SERIES
Paper roll wrinkles.
Cause 1:
Paper roll is not placed correctly, or placed on the skew.
Measure:
Place the paper roll correctly. (Refer to page 16.)
Cause 2:
Failure of the printer itself
Measure:
Ask the store where purchased.
Printer prints nothing.
Cause 1:
Ribbon cassette is not installed.
Measure:
Install the ribbon cassette. (Refer to page 143.)
Cause 2:
Ribbon cassette reaches its life, deteriorates, or is damaged.
Measure:
Replace the ribbon cassette with a new one.
Cause 3:
Status lamp “R OFF” is illuminated. (In case that nothing is printed on the receipt but not the journal)
Measure:
Depress the [LOG/RECEIPT] key to extinguish the lamp.
Cause 4:
Failure of the printer itself
Measure:
Ask the store where purchased.
Printing as a whole is too light.
Cause 1:
Ribbon cassette reaches its life, deteriorates, or is damaged.
Measure:
Replace the ribbon cassette with a new one. (Refer to page 143.)
Printing gets stained.
Cause 1:
Printer drum gathers paper dust.
Measure:
It is necessary to clean the inside of the printer, therefore ask the store where purchased.
Printing is uneven or too light.
Cause 1:
Ribbon cassette reaches its life, deteriorates, or is damaged.
Measure:
Replace the ribbon cassette with a new one. (Refer to page 143.)