Tripp Lite SNMP Solo MT-SE-37/02 User Manual
Page 19
Tripp Lite
Configuration
13
To assign the IP address of SNMP Solo, the gateway, and the
network, type at the prompt:
1, <space>, the IP address of the SNMP Solo, <space>,
MASK_BIT_COUNT, <space>, the IP address of the gateway.
The MASK_BIT_COUNT is used to indicate a mask for your
gateway. The meaning of the numbers used in the
MASK_BIT_COUNT will change based on the class of network
you have. A Class A network has 24 options, a class B network
has 16 options and a Class C has 8 options. The SNMP Solo
automatically discovers the type of network in use from the first
three digits of the IP address. The MASK_BIT_COUNT and the
corresponding mask for each type of network is shown below.
Class A Network
0
255.000.000.000
12
255.255.240.000
1
255.128.000.000
13
255.255.248.000
2
255.192.000.000
14
255.255.252.000
3
255.224.000.000
15
255.255.254.000
4
255.240.000.000
16
255.255.255.000
5
255.248.000.000
17
255.255.255.128
6
255.252.000.000
18
255.255.255.192
7
255.254.000.000
19
255.255.255.224
8
255.255.000.000
20
255.255.255.240
9
255.255.128.000
21
255.255.255.248
10
255.255.192.000
22
255.255.255.252
11
255.255.224.000
23
255.255.255.254