Tripp Lite SNMP Solo MT-SE-37/02 - Manual (Page 5)

Tripp Lite
Table of Contents i
Table of Contents
Introduction ............................ 1
SNMP Solo Features ............................ 1
Example Network With SNMP Solo ............... 2
SNMP Solo Package ....................... 3
SNMP Solo Package Contents .................... 3
The SNMP Solo Unit ........................... 3
Status LEDs ................................ 4
DIP Switches ............................... 4
Serial Port ................................ 5
Two 3.5” Diskettes .......................... 5
Configuration Cable .......................... 5
Power Supply ................................. 5
UPS Interface Cable .......................... 6
System Requirements ..................... 7
Initial Installation .................... 9
Verify The SNMP Solo Operation .............. 10
Configuration .......................... 11
Set IP And Gateway Addresses
And MIB System Group ...................... 12
Set Access Controls .......................... 15
Set Trap Receivers ........................... 16
Additional Setup Screen ...................... 18
Display Settings ............................. 18
Reset Configuration to Default ............... 20
To Save and Exit ............................. 20
Telnet Options ............................... 21
Upload Firmware .............................. 22
Exit Without Saving .......................... 22
Final Installation ..................... 23
Verify The SNMP Solo Operation ............... 23
Establish Network Communications ............. 24
Configuring the NMS .................... 25
General Network Management Stations .......... 25
HP OpenView Network Node Manager for HP-UX .. 25