Tripp Lite SNMP Solo MT-SE-37/02 - Manual (Page 33)

Tripp Lite
Configuring the NMS 27
Add SNMP Solo Object to the Management Map
The NMS will discover the NetMon and add it to the
Management map during its discovery pass.
Poll the Device OIDs
1. From the main menu, select Tools then the SNMP MIB
Browser.
2. From the SNMP MIB Browser box, select the IP
protocol and then enter the IP Address.
a)
select the profile to read.
b) select OK.
Set the Device OIDs
1. From the main menu, select Tools then SNMP MIB
Browser.
2. From the SNMP MIB Browser box, select Add.
3. From the SNMP Profile Editor box,
a) assign the profile a name, a community, and a
poll interval.
b) select the OID groups from the Group Choice
then select Add to transfer them to the Group
Selection(s).
c) Save the profile.
Ping the SNMP Solo
1. From the main menu, first select Fault, second Test
Connectivity, and third Once.
2. From the Test Connectivity box,
a) type in the IP address.
b) select Test.