Tripp Lite SNMP Solo MT-SE-37/02 - Manual (Page 6)

SNMP Solo
ii Introduction
Compile the Device MIB .................... 25
Add SNMP Solo Object to the Management Map .. 25
Poll the Device OIDs ...................... 26
Set the Device OIDs ....................... 26
Ping the SNMP Solo ........................ 26
Novell’s NetWare Management Station v.2.0 ... 26
Compile the Device MIB .................... 26
Add SNMP Solo Object to the Management Map 27
Poll the Device OIDs ...................... 27
Set the Device OIDs ....................... 27
Ping the SNMP Solo ........................ 27
SunConnect SunNet Manager ................... 28
Compile the Device MIB .................... 28
Add SNMP Solo Object to the Management Map 28
Poll the Device OIDs ...................... 29
Set the device OIDs ....................... 29
Ping the SNMP Solo ........................ 29
Appendix ............................... 30
Reference .................................... 30
Communities ................................. 30
IP Addresses ................................ 30
Subnetting and Subnet Masks ................. 31
Gateways .................................... 32
Glossary ..................................... 33
Troubleshooting .............................. 35
Placing a Technical Support Call ............. 36
Reference Worksheet .................... 38
TABLE OF FIGURES
Figure 1 SNMP Solo Monitoring a UPS on EtherNet ................. 2
Figure 2 SNMP Solo Network Connection Panel....................... 3
Figure 3 SNMP Solo Serial Port Panel....................................... 4
Figure 4 Communication Screen (Windows)............................. 10
Figure 5 Main Menu.................................................................. 11
Figure 6 IP Address for the SNMP Solo and More .................. 12
Figure 7 Access Controls ......................................................... 15
Figure 8 Trap Receivers ........................................................... 17
Figure 9 Additional Setup Screen............................................. 18
Figure 10 Display All Current Settings ..................................... 19
Figure 11 Reset Values To Default ........................................... 20
Figure 12 Save and Exit Messages For Configuration.............. 20
Figure 13 Telnet Options ........................................................... 21