Toshiba E-STUDIO 850 - Manual (Page 36)

34 1.BEFORE USING EQUIPMENT
1
4. Setting Copy Paper
About the “width” and the “length” of the original and the copy paper
Originals and copy paper whose size is LT can be set in both portrait and landscape directions. In the size
descriptions of original and copy paper throughout this manual, “A” in the figure below is called “length”
and “B” is called “width”. (In the figure below, the operator is standing in front of the equipment.)
When “B” is shorter than “A”, it is called “placing the original in a portrait direction.”
When “B” is longer than “A”, it is called “placing the original in a landscape direction.”
In this manual, when an original or copy paper which can be set in both in portrait and landscape direc-
tions is placed horizontally, its paper size is identified by adding “-R” at the end. (e.g. “LT-R”)
B
A
A
B
A
B