Toshiba M30 - Manual (Page 142)

User's Manual
8-8
O
PTIONAL
D
EVICES
5. Fit the memory module’s connectors into the socket at about a 45 degree angle
and push the module down until latches on either side snap into place.
Figure 8-6 Seating the memory module
CAUTIONS: 1. Be careful not to drop the screw inside the computer.
2. Do not touch the connectors on the memory module or
on the computer. Debris on the connectors may cause
memory access problems.
6. Seat the memory module cover and secure it with one screw.
7. Install the battery pack. Refer to Replacing the battery pack section in
Chapter 6, Power, for details.
8. Turn the power on and make sure the added memory is recognized. Open
System Properties in the Control Panel and click the General tab.
Removing memory module
To remove the memory module, make sure the computer is in boot mode then:
1. Turn off the power and disconnect all cables from the computer.
2. Turn the computer upside down and remove the battery.
3. Loosen one screw securing the memory module cover and lift off the cover.
Refer to figure 8-5.
4. Push the latches to the outside to release the module. A spring will force one
end of the module up.