S7 connection completion time-out, S8 comma pause time, S11 dtmf dialing speed – Toshiba M30 User Manual

Page 198: S12 escape guard time

Advertising
background image

User's Manual

D-4

A

PPENDIX

D

S7

Connection completion time-out

This register sets the time, in seconds, that the modem must wait before
hanging up because carrier is not detected. The timer is started when
the modem finishes dialing (originate), or goes off-hook (answer). In
originate mode, the timer is reset upon detection of an answer tone if
allowed by county restriction. The timer also specifies the wait for
silence time for the @ dial modifier in seconds. S7 is not associated with
the W dial modifier.

Range: 1-255

Default: 50

Units:

seconds

S8

Comma pause time

This register sets the time, in seconds, that the modem must pause
when it encounters a comma (,) in the dial command string. In some
countries/regions, S8 will set both wait before dialing and comma pause
time.

Range: 0-255

Default: 2

Units:

seconds

S11

DTMF dialing speed

This register determines the dialing speed which is prefixed for each
country/region.

Range: 50-255

Default: 95

Units:

.001 seconds

S12

Escape guard time

This register sets the value (in 20 millisecond increments) for the
required pause after the escape sequence.

Range: 0-255

Default: 50

Units:

.02 seconds

Advertising