Regulatory and safety information – UTStarcom UM100C User Manual

Page 32

background image


6.1 Regulatory Notices

UM100C complies with Parts 15, 22, and 24 of the FCC rules. It has been

tested with the typical personal computer with a USB port. This USB device

must not be co-located or operated in conjunction with any other antenna

or transmitter. If you use this USB device in any other configuration, the

FCC RF Exposure compliance limit can be exceeded.

6.2 Operating Conditions

1) This device may not cause harmful interference, and this device must

accept any interference received, including interference that may cause

undesirable operations.

2) The manufacturer stipulates that the antenna should be more than 1.5

cm (0.60”) from by-standers and 1.0cm (0.39”) from the user.

6.3 Warnings and Cautions

1) Modifying or changing this USB device without express authorization

can nullify compliance with RF exposure guidelines.

2) This USB device has been tested and found to comply with the limits

pursuant to Part 15, 22, and 24 of the FCC Rules. These limits are

designed to provide reasonable protection against harmful interference

when appropriately installed. This USB device generates, uses, and

can radiate radio frequency and, if not installed and used according to

the instructions provided, it may cause harmful interference to radio

communication. However, there is no guarantee that interference will not

occur in any particular installation.

3) If this USB device does cause harmful interference with radio or

television signals (determine this by turning the USB device off and on),

attempt to correct the interference by trying one or more of the following:

Reorient or relocate the antenna.

Increase the separation between the USB device and receiver.

Connect the USB device into an outlet on a circuit different from that to which

the receiver is connected.