USRobotics U.S. Robotics SureConnect ADSL Ethernet/USB Router - Manual (Page 186)

U.S. Robotics SureConnect ADSL Ethernet/USB Router User Guide
-enc LLC | VC Specifies the encapsulation type. The possible values are ‘llc’ or ‘vc’, which
represent Logical Link Control or VC multiplexing respectively.
-vpn OUI vpnId Enables VPN encapsulation. OUI is organizationally unique identifier. VpnId is
VPN index.
Example:
routedbridge atm0 enable 0 100 –o -enc LLC
Establishes a Routed Bridge connection on the WAN interface atm0. VPI, VCI values 0, 100 is
used for the ATM connection. LLC encapsulation will be used.
routedbridge atm0 disable 0 100
Disables the Routed Bridge connection.
1.25.2 Ipoa
ipoa <interface> disable <vpi><vci> -o [default] [-nhp <ip_address>]
ipoa <interface> enable <vpi><vci> -o [-enc LLC|VC] [default] [-nhp <ip_address>]
[-vpn <OUI> <vpnId>]
Configures the specified WAN interface to use IPoA, which is Classical IP over ATM including
Inverse ATM Arp. IPoA uses Inverse ATM Arp to get the peer IP address. The Maximum Transfer
Unit (MTU) for IPoA is 9182.
Note: In this case, if the peer does not support Inverse ATM Arp, then there will not be any traffic
flow. If the nexthop (-nhp option) or default PVC is configured per IPoA, then it does not use
Inverse ATM Arp to get the peer IP address.
Interface The name of the WAN interface. Typically this is ‘atm0’.
Enable Enables this IPoA interface.
Disable Disables this IPoA interface.
<vpi> <vci > These are the vpi, vci values on which ipoa has to be enabled/disabled. vpi,vci are
assigned with the vcadd command. The showatmconn command can also be used to list the
current ATM connections with their respective vpi and vci values. (Note the vcadd and
showatmconn commands are located in the “atm” directory).
-enc LLC | VC Specifies the encapsulation type. The possible values are ‘llc’ or ‘vc’ which
file:///P|/T_WRITER/Documentation/Released/9003%20(Guinness)/User%20Guide/9003%20(Guiness)%20prac%20template/cli.htm (62 of 71) [11/6/2002 8:58:46 AM]