USRobotics U.S. Robotics SureConnect ADSL Ethernet/USB Router User Manual
Page 6
U.S. Robotics SureConnect ADSL Ethernet/USB Router User Guide
3.
Enter VPI / VCI values.
4.
Click the radio button for the desired encapsulation mode: LLC/SNAP or VC
Multiplexing.
5.
Network Settings: Be sure that options Enable NAPT and Enable DHCP remain
selected.
6.
Click Add.
• If you chose PPPoE mode, follow these steps…
1.
Enter Username and Password.
2.
Select “Direct” Dialing mode. Only choose “Auto” if you prefer to start and stop
your connection while data is flowing.
3.
Enter the IDLE Timeout: This function adjusts the number of minutes of no traffic
before the connection terminates. The idle timeout connection terminates when you
select “Auto” Dialing Mode.
4.
Select the Authentication method: Chap or PAP or MS-CHAP.
5.
Enter VPI / VCI values.
6.
Click the radio button for the desired encapsulation mode: LLC/SNAP or VC
Multiplexing.
7.
Network Settings: Be sure that options Enable NAPT and Enable DHCP remain
selected.
8.
Click Add.
• If you chose PPPoA mode, follow these steps…
1.
Enter Username and Password.
2.
Select the Authentication method: Chap or PAP or MS-CHAP.
3.
Enter VPI / VCI values.
4.
Click the radio button for the desired encapsulation mode: LLC/SNAP or VC
Multiplexing.
5.
Network Settings: Be sure that options Enable NAPT and Enable DHCP remain
selected.
6.
Click Add.
• If you chose MER mode, follow these steps…
1.
Enter the WAN IP Address for your ISP.
2.
Enter WAN Subnet Mask for your ISP.
3.
Enter VPI / VCI values.
4.
Click the radio button for the desired encapsulation mode: LLC/SNAP or VC
Multiplexing.
5.
Network Settings: Be sure that options Enable NAPT and Enable DHCP remain
selected.
6.
Click Add.
Proceed to the Tools Menu to save your changes.
file:///P|/T_WRITER/Documentation/Released/900...ide/9003%20(Guiness)%20prac%20template/wui.htm (4 of 55) [11/6/2002 8:53:37 AM]