USRobotics U.S. Robotics SureConnect ADSL Ethernet/USB Router - Manual (Page 188)

U.S. Robotics SureConnect ADSL Ethernet/USB Router User Guide
pppoe <profile> -o <-if Interface> <-encap Encapsulation> <-restarttime Timeout >
<-auth Auth> <-myaddr IPAddr> <-peer PeerIPAddr> <-mtu MTU> <-mru MRU>
<-hwaddr Ethaddr> <-service ServiceName> <-acname ACName> <-tag HostTag>
<-user Username> <-pass Password> <-vpi Vpi> <-vci Vci> <-mode Mode>
<-idletime idleTimeout> <-nat [enable/disable]> <-netmask mask> <-vpn OUI vpnId>
Sets up a PPPoE profile.
Profile Profile number to configure. Specify an integer number from 0 through 7.
-if <interface> Interface name with unit number. Four PPP interfaces are available: ppp0, ppp1,
ppp2, ppp3, ppp4, ppp5, ppp6, ppp7
-encap <encapsulation> Encapsulation type. Possible values are LLC (Logical Link Control) or
VC (VC Multiplexing).
-restarttime <timeout> Timeout in milliseconds. The default is 3 seconds (3000 milli seconds).
-auth <authentication> Authentication type (pap, chap, mschapv1, mschapv2).
-myaddr <ip_addr> Desired self IP Address (eg 192.168.26.7). Expressed in dot notation.
-peer <peer_addr> Peer IP Address to optionally specify the address of the Internet Service
Provider. Expressed in dot notation.
-mtu <mtu> Maximum Transmission Unit expressed in bytes. The default is 1492.
-mru <mru> Maximum Receive Unit, negotiated in LCP. The default is 1492.
-hwaddr <addr> Hardware address of the router for this connection. Typically, one of the Ethernet
hardware addresses of the router are used for this. The address is specified with ‘:’ used as a
delimiter between byte values (eg 10:11:12:13:14:15).
-service <service_name> Service Name.
-acname <ac_name> Access Concentrator name.
-tag <host_tag> Use host unique tag.
-user <user> Username. This string can be up to 30 characters.
-pass <password> Password. This string can be up to 30 characters.
-vpi <vpi> The ATM vpi value which was assigned in a vcadd command or listed in a
atmshowconn command.
-vci <vci> The ATM vci value which was assigned in a vcadd command or listed in a
atmshowconn command.
-mode <mode> Mode can be AUTO or DIRECT. In case the mode is set to AUTO, the PPPoE
file:///P|/T_WRITER/Documentation/Released/9003%20(Guinness)/User%20Guide/9003%20(Guiness)%20prac%20template/cli.htm (64 of 71) [11/6/2002 8:58:46 AM]