VIEWSONIC WPD-100 VS13789 - Manual (Page 27)

ViewSonic WPD-100 21
The length of WEP key depends on the type of WEP key
you selected. You can input 10 or 26 hexadecimal
characters and 5 or 13 ASCII characters as WEP key.
Use 802.1x If the access point you wish to connect requires 802.1x
authentication, please click on ‘Use 802.1x’ box, then click
‘802.1X’ tab to set 802.1x parameters.
To set 802.1x authentication for the access point. Please click ‘802.1X’ tab:
Here are descriptions of every setup item:
Item Name
Description
EAP Method Select 802.1x EAP method from dropdown menu. Please
ask the administrator of the access point you wish to
connect to select a correct EAP method.
Tunnel
Authentication Select 802.1x tunnel authentication type from dropdown
menu. Please ask the administrator of the access point you
wish to connect to select a correct tunnel authentication
method. This pull down menu is only available when
authentication type you use is 'PEAP', ‘TLS / Smart Card', or
'TTLS'.
When you use 'EAP-FAST' as authentication type, the
protocol setting is always 'Generic Token Card' and can not
be changed. You also need to select ‘Soft Token’ or ‘Static
Password’ as password in ‘ID \ Password’ setting.
’EAP Fast’ authentication type also have a sub-menu to set
EAP fast-specific parameters: