VIEWSONIC WPD-100 VS13789 - Manual (Page 28)

ViewSonic WPD-100 22
If you need to use protected authentication credential, check
‘Use protected authentication credential’ box, and click
‘Import’ to load .pac credential file; to remove a loaded
credential file, click ‘Remove’.
Session
Resumption You can enable or disable session resumption here. If you
don’t know if you should enable session resumption or not,
please ask your 802.1x authentication administrator.
ID \ Password
tab Input 802.1x username (ID) and password and other
information if it is required here. Click ‘Show Password’ to
show the password you typed.
Client
Certification
tab Use this tab to select a local certificate from dropdown
menu. If the access point you wish to connect required a
specific client certificate, the certificate must be installed on
your computer, and you can select the certificate here.
Server
Certification
tab Use this tab to use server-based certification. Please select
a CA (Certificate Authority) from dropdown menu. If
intermediate certificates are allowed, please select ‘Allow
intermediate certificates’. Also, if you need to specify CA
server’s name, you can specify it in ‘Server name’ field. You
can select ‘Server name must match’, so the CA server’s
name must be the same with the value you set in ‘Server
name’ field; If only the domain name part of full server name
must the same with the value you set in ‘Server name’ field,
select ‘Domain name must end in specified name’.
After you complete all information related to the access point, click ‘OK’ to
save the profile, or click ‘cancel’ to cancel adding a new profile.
If the profile is created, you will see the information in the Profile List.