Vision Fitness T9500 - Manual (Page 43)

Revision: 1.0 Date: 1999-09-01
B. Steps:
2. Connection cables & short pin is ready.
3. Turn ON the power switch.
4. Find out the software version file in the computer and then actuate/open the file by “click”
the mouse twice.
5. The computer will be turned into DOS mode, and run the installation work. Automatically.
(It takes around 2 minutes for installation.)
6. After competed installation, the computer will show passing on the computer screen.
7. Turn OFF the power switch.
8. Disconnect the cables.
9. Turn ON the power switch and then enter into the engineering mode to confirm if the
software
had been installed/upgraded.
6-2