Western Telematic IPS-15 - Manual (Page 18)

2. Test Switching Commands: When the IPS-15 is powered up,
the Switched AC Outlet will be set in the ON position. To
test On/Off/Reboot functions, proceed as follows:
a) Reboot Outlet: To initiate a boot cycle, go to the IPS>
command prompt, type /BOOT 1 and press [Enter].
Power to the Switched AC Outlet will be switched OFF.
After the Boot Delay Period (Default = 5 Seconds), power
to the Switched Outlet will then be switched back ON.
b) Switch Outlet OFF: To power the Switched AC Outlet
OFF, go to the IPS> command prompt, type /OFF 1 and
press [Enter]. Power to the Switched Outlet will be
switched OFF.
c) Switch Outlet ON: To power the Switched AC Outlet
ON, go to the IPS> command prompt, type /ON 1 and
press [Enter]. Power to the Switched Outlet will be
switched ON.
3. Exit Command Mode: When you have finished testing the
IPS unit, type /X and press [Enter] to exit from the
Command Mode. Note that it is recommended to always
disconnect using the /X command. If the /X command is not
invoked at the end of a command session, then the IPS will
not exit from command mode until the No Activity Timeout
feature closes the session. In this case, further access to the
IPS command mode may not be allowed until the current
session times out.
This completes the introductory overview of the IPS. Please
proceed to Sections 4 and 5 for complete installation and
configuration procedures.
3-8
IPS Internet Power Switch; User's Guide