Western Telematic IPS-15 - Manual (Page 46)

2. Status Screen Suppressed: The status screens will not be
automatically displayed after commands are successfully
executed. Note however, that the /S command can still be
invoked to display the status screen if needed.
3. "Sure?" Prompt Suppressed: All commands are executed
without prompting for user confirmation.
4. Error Messages Suppressed: If the [Enter] key is pressed
without entering a command, the IPS will not respond with
the "Invalid Command" message. Note however, that an error
message will still be generated if commands are invoked
using invalid formats or arguments.
All other status display and configuration commands will still
function as normal.
6.6. Manual Operation
In addition to the command driven functions available via the Web
Browser Interface and Text Interface, the IPS's switched plugs can
also be toggled On and Off manually. To manually toggle plug(s)
On or Off, press the Manual Control Button, and hold it down for
approximately one second; the corresponding plug(s) will be toggled
On or Off.
If desired, the Button Mode Parameter (which is accessed via the
General Parameters Menu in both the Web Browser Interface and
Text Interface), can be used to disable the manual power button
completely. In addition, the Button Mode Parameter also allows you
to restrict manual control to the master unit's switched plug only, or
allow the manual control button to control switched outlets on the
IPS-15 and all connected Satellite Units.
For more information on the Button Mode Parameter, please refer to
Section 5.3.1.
6-8
IPS Internet Power Switch; User's Guide