Western Telematic IPS-15 - Manual (Page 29)

· User Name: (Optional) The User Name allows you to set up an
additional layer of security for web access to the command mode
by requiring that users correctly enter a name in addition to a
password. Note that the User Name is only required when the
unit is accessed via the Web Interface. (16 Characters,
Default = undefined.)
· Site ID: Defines a brief text message, which can be used to
identify the installation location of the IPS unit. (Up to 32
characters, Default = undefined.)
· Serial Port Mode: Sets up the IPS Console Port for use with
either a local PC ("Console") or an external modem ("Modem").
Note that when the Serial Port Mode is set at "Modem" the
modem initialization string will be sent every 15 minutes.
(Default = Console.)
· Modem Initialization String: Defines a command string (up to
32 characters long) which can be sent out the serial Console Port
to initialize an external modem. If the Serial Port Mode is set to
"Console", the modem initialization string will not be sent. For
more information on initialization commands, refer to the user's
guide for your modem. (Default = ATE0M0Q1&C1&D2S0=1)
· Baud Rate: The Baud Rate for the IPS Master Unit's Console
Port. (Default = 9600 bps, No Parity, 8 Data Bits, 1 Stop Bit.)
Note: When this setting is changed, the new baud rate
will not be applied until the user exits and then re-
enters the IPS command mode.
5-7
Section 5: Configuration
GENERAL PARAMETERS:
1. System Password: (defined)
2. User Password: (defined)
3. User Name: (undefined)
4. Site ID: WTI Internal Test Unt v 1.01
5. Serial Port Mode: Console
6. Modem Init. String: ATE0M0Q1&C1&D2S0=1
7. Baud Rate: 9600,N,8,1
8. Command Echo: On
9. Inactivity Timeout: 5 Min
10. Command Confirmation: On
11. Automated Mode: Off
12. Button Mode: One
A. Default Parameters
Enter Selection or <ESC> to Exit ...
Figure 5.4: General Parameters Menu - Text Interface