Western Telematic IPS-15 - Manual (Page 32)

Please note that the major difference between the Web Browser
Interface and Text Interface in this case, is that the Web Interface
allows you to select parameters for all five plugs/zones from a single
menu, where as the Text Interface includes a separate menu for each
plug/zone. The Plug Parameters Menu allows the following
parameters to be defined:
· Name: Assigns a name to the plug. (Up to 32 Characters,
Default = undefined.)
· Boot Delay: During a Boot Cycle, power to the outlet is
switched off and then switched back on. The Boot Delay is the
amount of time that elapses between power off and power on.
(Default = 5 Seconds.)
5.3.3. Network Parameters Menus
The Network Parameters Menus are used to select the IP Address
and other network parameters.
Web Browser Interface: Click the "Setup" button to access the
Setup Menus, and then click the "Network Parameters" button. The
Web Parameters Menu will be displayed as shown in Figure 5.7
Text Interface: Type /N and press [Enter]. The Network
Parameters Menu will be displayed as shown in Figure 5.8.
Notes:
· Although both the Web Browser Interface and Text
Interface both allow configuration of the same
network parameters, note that when parameters are
defined via the Text Interface, the IP Security feature
is configured via a separate submenu. For more
information on IP Security, please refer to
Section 5.3.3.1.
· Settings for network parameters depend on the
configuration of your individual network. Contact
your network administrator for appropriate settings.
The Network Parameters Menu allows the following parameters to
be defined. Except where noted, all parameters listed here are
available via both the Web Browser Interface and the Text Interface.
· IP Address: Defines the IP address for the IPS unit.
(Default = 192.168.168.168.)
· Subnet Mask: Defines the Subnet Mask for the IPS unit.
(Default = 255.255.255.0.)
5-10
IPS Internet Power Switch; User's Guide