Western Telematic IPS-15 User Manual

Page 27

Advertising
background image

5.3. Configuration Menus

As described in the sections that follow, configuration parameters

for the IPS can be selected via the Web Browser Interface or Text

Interface. Although the Web Browser and Text Interface provide

two separate means for selecting parameters, both interfaces allow

access to essentially the same set of parameters, and parameters

selected via one interface will also be applied to the other.

Web Browser Interface: Click the "Setup" button to gain access to

the configuration menus; a row of buttons will be displayed along

the right hand edge of the screen. Click the appropriate button to

access the desired menu. Note the following:

·

Newly selected parameters will not be applied until you click

the "Apply" button.

·

Click "Switch Panel" to return to the main status screen.

Text Interface: Refer to the Help Screen (/H) and then enter the

appropriate command to access the desired menu. When the

configuration menu appears, key in the number or letter for the

parameter that you wish to define and follow the instructions in the

resulting submenu. Note the following:

·

To exit from a parameters menu, press the [Esc] key.

The following sections describe the options and parameters that are

available in each of the configuration menus. Please note that

essentially the same selection of parameters and options are

available via both the Web Browser Interface and Text Interface.

Note: Configuration menus are only available when

the System Mode is active. Configuration menus are

not available if you have logged in with the User

Password.

5.3.1.

The General Parameters Menus

The General Parameters Menus allow you to select parameters such

as the Passwords, User Name, Site I.D., Modem Commands and

other options.

Web Browser Interface: Click the "Setup" button to access the

Setup Menus, and then click the "General Parameters" button. The

General Parameters Menu will be displayed as shown in Figure 5.3.

Text Interface: Type /G and press [Enter]. The General

Parameters Menu will be displayed as shown in Figure 5.4.

5-5

Section 5: Configuration

Advertising