Western Telematic IPS-15 - Manual (Page 48)

7.2. Restoring Saved Parameters
This section describes the procedure for using ProComm to send
saved parameters to the IPS.
Note: Parameters that have been saved to an ASCII
file can only be restored via the Text Interface. This
procedure cannot be performed via the Web Browser
Interface.
1. Start your communications program and access the IPS
command mode via the Text Interface as described in
Section 5.2.2.
2. If the Password Prompt is displayed, key in your System
Level Password and press [Enter].
3. Configure your communications program to upload an ASCII
text file.
4. Upload the file with the saved parameters. If necessary, key
in the file name and directory path.
5. When the upload is complete, make certain to terminate the
communications program's upload mode.
Note:
· The current On/Off status of each IPS plug will not be
saved or restored. However, the selected default
On/Off setting for each plug will be saved and
restored.
· When the configuration file is sent to the IPS via
telnet, the unit's IP Address, Subnet Mask, and
Gateway Address cannot be altered.
At this point, saved parameters should have been restored to the IPS
unit. Check the Plug Status Screen, General Parameters Menu, Plug
Parameters Menu and Network Parameters Menu to make certain
that saved parameters have been accurately restored.
7-2
IPS Internet Power Switch; User's Guide