Western Telematic IPS-15 - Manual (Page 24)

5.2. Communicating with the IPS
In order to configure the unit or invoke command functions, the user
must first connect to the IPS and access the command mode. As
discussed in Section 3, the IPS-15 offers two separate command
interfaces: the Web Browser Interface, and the Text Interface.
In addition, the IPS also offers three different methods for accessing
the command mode; via network, via external modem, or via local
console. The Web Browser Interface is only available when the IPS
is contacted via network, and the Text Interface is available via
network, modem or local PC.
The sections that follow describe the procedure for accessing the
Web Browser Interface or the Text Interface.
5.2.1. Accessing the Web Browser Interface
In order to issue commands via the Web Browser Interface, the IPS
Master Unit must be connected to a TCP/IP network, and your PC or
workstation must be equipped with a JavaScript enabled web
browser (such as Internet Explorer or Netscape Navigator.)
1. Start your JavaScript enabled Web Browser.
2. Key the unit's IP address (default = http://192.168.168.168)
into the web browser's address bar, and then press [Enter].
5-2
IPS Internet Power Switch; User's Guide
Figure 5.1: Plug Status Screen - Web Browser Interface