Whirlpool GHW9100L - Manual (Page 31)

4 - 3
Begin by removing the cycle selector knob. There
are eight tabs securing the Touch Pad/LED As-
sembly to the console.
(Fig. 4-8) A flat bladed
screwdriver will be helpful in releasing these tabs.
Fig. 4-8
REMOVING THE WASHER DOOR AND DOOR SWITCH
The washer door can be removed by removing
the upper left shield cover and hinge cover. Open
the door and remove three screws securing the
door hinge to the washer front and lifting upward.
Screw
Fig. 4-10
Access to the door switch requires that the water
seal boot be removed from the front of the washer.
(Fig. 4-11) Use a flat bladed screwdriver at the
location of the retainer spring and pull the retainer
forward and then off the perimeter of the boot.
Ease the edge of the boot off of the lip of the
washer front near the door switch. (Fig
. 4-12)
Remove enough of the boot to gain access to
the door switch behind the washer front panel.
Fig. 4-11
Boot
Pulled
Back
Fig. 4-12
The door switch is secured to the washer front
panel with three screws. Once these screws are
removed, the door switch will remain in place until
it is lifted slightly and pulled back from the washer
front panel.
Fig. 4-13
Door Switch
Assembly
Typical Release Tab
Screw
Retainer
Spring
Tab Tab
Fig. 4-9
Tab
Tab
Release these tabs in sequence from left to right
around the Touch Pad/LED Assembly until all of
the tabs are free and the Assembly can be lifted
from the console.
(Fig. 4-9)
Tab Tab Tab Tab