Whirlpool GHW9100L - Manual (Page 33)

4 - 5
To remove the detergent dispenser motor assem-
bly, disconnect the cam follower spring and lift
the cam follower from the diverter cam and ro-
tate the diverter cam clockwise to access the
motor mounting screws.
REMOVING THE DETERGENT
DISPENSER ASSEMBLY
The Detergent Dispenser Assembly is located
under the washer top. Begin by removing the
washer top, console and front panel.
Separate the water inlet and window washer tube
from the boot.
Pull the water inlet tube from the outlet connector
of the detergent dispenser.
(Fig. 4-16)
NOTE: When reinstalling the water inlet tube,
wet the water inlet gasket on the detergent dis-
penser with water only. Do not use any other lu-
bricant. Align the locator nib on the water inlet
tube with the indentation on the dispenser con-
nector and slide the tube onto the detergent dis-
penser assembly.
Remove the screw securing the front of the de-
tergent dispenser assembly to the top front frame
member.
(Fig. 4-16)
Screw
Fig. 4-16
Disconnect the vent tube from the detergent dis-
penser assembly.
(Fig. 4-17)
Remove the screw securing the detergent dis-
penser assembly to the top left frame member.
(Fig. 4-17) Slide the assembly back slightly and
lift the assembly out.
Screw
Vent
Tube
Fig. 4-17
Fig. 4-18
Rotate Clockwise
Screws
(Under
Cam)
Motor
Water Inlet
Tube