Whirlpool GHW9100L - Manual (Page 34)

4 - 6
REMOVING THE DRIVE MOTOR
The drive motor can be removed once the back
panel has been removed.
Twelve screws secure the back panel to the
washer. Remove the 12 screws and remove the
back panel. Remove the Drive Belt.
Disconnect the wiring harness connectors and
ground wires from the drive motor terminals. Push
the wiring harness tie from the motor mounting
bracket.
Remove the mounting bolt securing the motor to
the tub.
(Fig. 4-22)
Mounting
Bolt
Fig. 4-22
REMOVING THE PUMP ASSEMBLY
The pump assembly can be accessed once the
toe panel has been removed.
To remove the pump assembly, begin by open-
ing the door covering the wiring harness connec-
tor and disconnect the wiring harness from the
pump motor terminals. Remove the screw se-
curing the pump assembly to the washer frame.
(Fig. 4-23) Once the pump is removed the drain
hose and tub outlet hose can be removed.
Fig. 4-23
Screw
REMOVING THE
CENTRAL CONTROL UNIT
AND PRESSURE SWITCH
The Central Control Unit is a single assembly and
does not contain any serviceable parts. It can be
removed by lifting the top plastic tabs securing it
to the back cabinet frame and sliding it towards
the front of the washer.
(Fig. 4-19)
To remove the pressure switch, first remove the
wiring harness retainer from the side of the cabi-
net.
(Fig. 4-20)
Fig. 4-19
Pressure Switch
Then disconnect the wiring harness connectors
and the pressure hose and turn the pressure
switch counterclockwise to release it from the
cabinet.
(Fig. 4-21)
Wiring Harness
Retainer
Fig. 4-20
Fig. 4-21
Tabs