The status screens, The circuit status screen – Western Telematic PLS-345 User Manual
Page 35
6.
The Status Screens
The PLS Status Screens are used to display current conditions of
the three switched A/B circuits and the network interface. There
are two status screens; the Circuit Status Screen (/S), and the
Network Status Screen (/SN).
6.1. The Circuit Status Screen
The Circuit Status Screen lists the current A/B settings for the
PLS-345's three switched circuits, and also summarizes user-
selected parameters, such as Command Echo, Inactivity Timeout,
and Command Confirmation.
As shown in Figure 6.1, the Circuit Status Screen lists the
following items:
1. Site ID Message: The currently defined Site ID message.
Note that the site ID message is defined via the General
Parameters Menu (/G).
2. Ckt #: The circuit numbers for the PLS's three A/B
circuits.
6-1
Physical Layer Switch v1.00
Site ID: PLS-345_TEST_IRVINE_CALIFORNIA
CKT# | From
| To
| POS | MON | Default |
-----+------------------+------------------+-----+-----+---------|
1
| COMMON_LINE_1
| LINE_B1
| B |
|
A
|
2
| COMMON_LINE_2
| LINE_A2
| A | * |
A
|
3
| COMMON_LINE_3
| LINE_A3
| A | * |
A
|
-----+------------------+------------------+-----+-----+---------|
Command Echo:
On
Inactivity Timeout:
30 Min
Command Confirmation:
On
Automated Mode:
Off
Monitor Mode:
On
Monitor Input Level:
1 - High
"/H" for help.
Figure 6.1: The Circuit Status Screen