Western Telematic PLS-345 - Manual (Page 36)

3. From: The user-defined name for the Common Line (C)
for each of the three A/B circuits. Note that if the
Common Line name has not been defined, this field will
remain empty.
4. To: The user defined name for the currently selected "A"
or "B" line for each of the three A/B circuits. Note that if
the A/B line names have not been defined, this field will
remain empty.
5. POS (Position): The currently selected "A" or "B" line
for each of the three A/B circuits. This field will list
either "A" or "B" to indicate which line is currently
connected to the Common Line.
6. MON (Monitor Mode): An asterisk will appear in this
field for each circuit that has been configured for the
Monitor Mode. An asterisk indicates that the circuit will
be monitored if the Monitor Mode is enabled. Note that if
the Monitor Mode has been configured at this circuit, but
not actually enabled, an asterisk will still appear in this
field.
7. Default: The default A/B position that has been defined
for this circuit using the Circuit Parameters Menu. This
does not reflect the currently selected A/B Line, but
indicates which A/B line will be selected if the PLS is
reset to default settings.
8. Other Parameters: The lower half of the status screen
lists currently selected values for most of the parameters
that are selected via the General Parameters Menu, plus the
status of the Monitor Mode.
6-2
PLS-345 - Physical Layer Switch; User's Guide