Western Telematic PLS-345 - Manual (Page 41)

The Command Confirmation Prompt:
Normally, when the /A or /B commands are invoked, the PLS
will prompt you for confirmation before actually implementing
the command. If you wish to suppress this confirmation prompt,
and execute commands without confirmation, you can employ
one of the following methods:
· Include the ",y" option in the command line (e.g. /A 1,y.)
· Disable Command Confirmation as described in Section 5.4.
· Enable the Automated Mode as described in Section 5.4.
7.2.2. The /D Command
The /D command can be used to switch all three PLS-345 circuits
to their user-defined default A/B positions. Default A/B
positions are defined via the Circuit Parameters Menus (/P n.)
When the /D command is invoked, the PLS will set all three
circuits to their default A/B positions, and then display the status
screen, followed by the PLS> command prompt.
The Command Confirmation Prompt:
Normally, when the /D command is invoked, the PLS will prompt
you for confirmation before actually implementing the command.
If you wish to suppress this confirmation prompt, and execute
commands without confirmation, you can employ one of the
following methods:
· Include the ",y" option in the command line (e.g. /D,y.)
· Disable Command Confirmation as described in Section 5.4.
· Enable the Automated Mode as described in Section 5.4.
7-3
Section 7: Operation