Western Telematic PLS-345 - Manual (Page 50)

/SN Display Network Status
Displays a status screen (Figure 6.2), which lists current network
parameters, such as the TCB port, Telnet port, and network
status.
Command Format: /SN [Enter]
Response: Displays Network Status Screen, followed by the
PLS> command prompt.
Command Availability: System and User.
10.2. Configuration Commands
These commands are used to access the configuration menus,
which are used to select operating parameters for the PLS-345.
/G View/Set General Parameters
Displays the General Parameters Menu (Figure 5.2), which is
used to define parameters such as the System and User
Passwords, Site ID, Modem command strings, and other features.
The General Parameters menu also includes an option which
allows the user to set all parameters to their default values. For
more information on the General Parameters Menu, please refer
to Section 5.4.
Command Format: /G [Enter]
Response: Displays General Parameters Menu.
Command Availability: System Only.
/P [n] View/Set Circuit Parameters
Displays the Circuit Parameters Menus (Figure 5.3), which are
used to select operating parameters for each of the PLS-345's
three switched circuits. For more information on the Circuit
Parameters Menus, please refer to Section 5.5.
Command Format: /P [n] [Enter]
Where "n" is the common name or number of the circuit. For
example, to configure Circuit 2, type /P 2 [Enter], or to
configure a circuit named "vpn", type /P vpn [Enter]
Response: Displays the Circuit Parameters Menus.
Command Availability: System Only.
10-2
PLS-345 - Physical Layer Switch; User's Guide