Western Telematic PLS-345 - Manual (Page 54)

/X Exit/Disconnect
Exits from command mode. When you have contacted the PLS
via network, the unit will exit command mode and the network
connection will be terminated. When you have contacted the
PLS via modem, the unit will exit command mode and the
modem will hang up. When you have contacted the PLS via a
local PC connected to the PLS Console Port, the unit will exit
command mode.
Note: When communicating with the PLS, it is
recommended to always disconnect using the /X
command. If the /X command is not invoked at the
end of a command session, then PLS will not exit
from command mode until the No Activity Timeout
feature closes the session. In this case, further
access the PLS command mode will not be allowed
until the current session times out.
Command Format: /X [Enter]
Command Arguments:
,y Suppress Confirmation (Sure) Prompt. For example,
"/X,y" will cause the PLS to exit the current command
mode session without displaying the confirmation
prompt.
Response: Displays message indicating that you are about to
exit command mode, waits for user confirmation (unless
suppressed) and then exits from command mode.
Command Availability: System and User.
10-6
PLS-345 - Physical Layer Switch; User's Guide