Western Telematic PLS-345 - Manual (Page 51)

/N View/Set Network Parameters
Displays the Network Parameters Menu (Figure 5.4), which is
used to define the IP Address, Subnet Mask, Gateway Address
and access the IP Security Menu. For more information on the
Network Parameters Menu, please refer to Section 5.6.
Command Format: /N [Enter]
Response: Displays Network Parameters Menu.
Command Availability: System Only.
/M View/Set Monitor Mode Parameters
Displays the Monitor Mode Parameters Menu (Figure 5.6), which
is used to enable and configure the Monitor Mode feature. The
Monitor Mode allows the PLS to perform automatic A/B
switching, based on the signal level of an RS-2323 line or
contact connected to the Monitor Input Port. For more
information on the Monitor Mode, please refer to Section 5.7.
Command Format: /M [Enter]
Response: Displays Monitor Mode Parameters Menu.
Command Availability: System Only.
/DL Download Configuration to File
Saves currently defined PLS configuration parameters to an
ASCII file on your PC. This allows you to either "back-up"
parameters as a safety measure, or download the parameters to
another PLS-345 if several units will be configured with the
same parameters. For more information on saving configuration
parameters, please refer to Section 8.
Command Format: /DL [Enter]
Response: Prompts the user to configure terminal application to
receive parameter file, waits for confirmation, and then
downloads configuration parameters to an ASCII file on your
hard drive when confirmation is given.
Command Availability: System Only.
10-3
Section 10: Command Summary