Configure mode, 3 configure mode – ZyXEL Communications ZyXEL Dimension ES-3124 User Manual
Page 218
Dimension ES-3124 Ethernet Switch
30-10 Introducing the Commands
Table 30-2 Command Summary: Enable Mode
COMMAND DESCRIPTION
mac-flush
Clears the MAC address table.
<port-num>
Removes all learned MAC address on
the specified port(s).
erase running-config
Resets to the factory default settings.
boot config
<index>
Restarts the system with the specified
configuration file.
reload config
<index>
Restarts the system and use the
specified configuration file.
write memory
Saves the configuration to the
configuration file the switch is currently
using.
<index>
Saves the configuration to the specified
configuration file on the switch.
copy running-config
tftp
<ip> <remote-file>
Backs up running configuration to the
specified TFTP server with the specified
file name.
tftp Config <index> <ip>
<remote-file>
Restores configuration with the specified
filename from the specified TFTP
server.
flash <ip> <remote-
file>
Restores firmware via TFTP.
ping <ip|host-name>
[<in-band|out-of-
band|vlan <vlan-id>]
[size <0-1472>]
[-t]
Sends a Ping request to an Ethernet
device.
traceroute <ip|host-name>
[in-band|out-of-
band|vlan <vlan-id>]
[ttl <1-255>]
[wait <1-60>]
[queries <1-10>]
Determines the path a packet takes to a
device.
ssh <1|2> <[user@]dest-
ip>
Connects to an SSH server with the
specified SSH version.
30.9.3 Configure
Mode
The following table lists the commands in Configuration (or Config) mode.
Table 30-3 Command Summary: Configure Mode
COMMAND DESCRIPTION
help
Displays help information.