ZyXEL Communications ZyXEL Dimension ES-3124 - Manual (Page 70)

Dimension ES-3124 Ethernet Switch
6-8 Basic Setting
Table 6-3 Switch Setup
LABEL DESCRIPTION EXAMPLE
Join Timer Join Timer sets the duration of the Join Period timer for GVRP in milliseconds.
Each port has a Join Period timer. The allowed Join Time range is between 100
and 65535 milliseconds; the default is 200 milliseconds. See the chapter on
VLAN setup for more background information.
200 milliseconds
(default)
Leave Timer Leave Timer sets the duration of the Leave Period timer for GVRP in
milliseconds. Each port has a single Leave Period timer. Leave Time must be two
times larger than Join Timer; the default is 600 milliseconds.
600 milliseconds
(default)
Leave All
Timer
Leave All Timer sets the duration of the Leave All Period timer for GVRP in
milliseconds. Each port has a single Leave All Period timer. Leave All Timer must
be larger than Leave Timer; the default is 10000 milliseconds. 1000
milliseconds
(default)
Priority Queue Assignment
IEEE 802.1p defines up to 8 separate traffic types by inserting a tag into a MAC-layer frame that contains bits to
define class of service. Frames without an explicit priority tag are given the default priority of the ingress port. Use
these fields to configure the priority level-to-physical queue mapping.
The switch has 8 physical queues that you can map to the 8 priority levels. On the switch, traffic assigned to higher
index queues gets through faster while traffic in lower index queues is dropped if the network is congested.
See also Queuing Method and 802.1p Priority in Port Setup for related information.
Priority Level (The following descriptions are based on the traffic types defined in the IEEE 802.1d standard (which
incorporates the 802.1p).
Level 7 Typically used for network control traffic such as router configuration messages.
Level 6 Typically used for voice traffic that is especially sensitive to jitter (jitter is the variations in delay).
Level 5 Typically used for video that consumes high bandwidth and is sensitive to jitter.
Level 4
Typically used for controlled load, latency-sensitive traffic such as SNA (Systems Network
Architecture) transactions.
Level 3
Typically used for “excellent effort” or better than best effort and would include important business
traffic that can tolerate some delay.
Level 2 This is for “spare bandwidth”.
Level 1
This is typically used for non-critical “background” traffic such as bulk transfers that are allowed but
that should not affect other applications and users.
Level 0 Typically used for best-effort traffic.
Apply Click Apply to save your changes back to the switch.
Cancel Click Cancel to begin configuring this screen afresh.
6.6 IP Setup
Use the IP Setup screen to configure the default gateway device, the default domain name server and add IP
domains.