ZyXEL Communications IES-612-51A - Manual (Page 325)

Chapter 47 IGMP Commands
IES-612-51A User’s Guide
325
where
This command displays the current multicast VLAN settings. In the state column, “-” indicates
the multicast VLAN is not active while “V” indicates the multicast VLAN is active.
Figure 189 Multicast VLAN Show Command Example
47.8.6 Multicast VLAN Group Set Command
Syntax:
ras> switch igmpsnoop mvlan group set <vid> <index> <start-mcast-ip> <end-
mcast-ip>
where
This command creates a multicast VLAN group. The following example creates a multicast
VLAN with VID 10 and group index 1. The multicast address range is 224.224.224.1 ~
224.224.224.10.
Figure 190 Multicast VLAN Group Set Command Example
47.8.7 Multicast VLAN Group Delete Command
Syntax:
ras> switch igmpsnoop mvlan group delete <vid> <index>
where
<vlanlist> = You can specify a single VLAN: <1>, all VLAN: <*>, a list
of VLAN: <1,3>, you can also include a range of VLAN:
<1,5,6~10>.
ras> switch igmpsnoop mvlan show 1
vid name F:fixed X:forbidden U:untag T:tag
---- ---------------- ----------------------------------------
<vid> = The multicast VLAN ID [1 – 4094].
<index> = 1..16; a unique number for this setting.
<start-mcast-
ip>
= Start of the multicast IP address range.
<end-mcast-ip> = End of the multicast IP address range.
ras> switch igmpsnoop mvlan group set 10 1 224.224.224.1
224.224.224.10
<vid> = The multicast VLAN ID [1 – 4094].
<index> = 1..16; a unique number for this setting.