Zoom 8080 - Manual (Page 19)

In the Edit mode, you can change the parameters of the various effects, to create your own sound effects.
■ 18
Advanced
Operation
Activating the Edit mode
In Play mode, select
the patch you want to
edit.
("Selecting a patch" p. 11). 1
Press the .
The 8080 enters the Edit mode.
Pressing any effect key will cause
the key indicator to flash. This
shows that effect module on/off
settings and parameters of this
effect can now be edited.
For a detailed explanation of editing
procedures, see p. 21.
EDIT/EXIT key 2
When editing is
terminated, press the
again.
The 8080 returns to the Play mode.
EDIT/EXIT key
3
CONTROL
PEDAL
CONTROL
PEDAL
CONTROL
SWITCH
DECREASE
–(TAP/HOLD)
INCREASE
USER
FUNCTION BANK
MAX
CONTROL SWITCH INDICATOR
1/2
MIN
BLINK
(DLY:TAP)
STORE (EXECUTE) UTILITY PAGE TYPE – +
PRESENCE OUTPUT
3 4
1 2
MAX MIN
MAX MIN MAX MIN
MAX MIN
GROUP COMPARE
FINE TUNE
Super ADVANCED GUITAR EFFECTS PROCESSOR
COMP EFF1 DIST EQ EFF2 EFF3 DLY REV TOTAL
EDIT
EXIT
2, 3
2
Display
EDIT/EXIT key
Effect keys
EDIT
EXIT
COMP EFF1 DIST EQ EFF2 EFF3 DLY REV
TbOD OD= 16 EQ=+10
LVL= 5 ZNR=off
01 8080LEAD LVL=100
é AMP ¡VOL ™OFF ßHLD
01 8080LEAD LVL=100
AMP ¡VOL ™OFF ßHLD
COMP EFF1 DIST EQ
Editing a Patch
(Edit Mode Operation)
You can select a patch from the USER or PRESET groups for editing. But because PRESET group patches are read-only,
you cannot store an edited patch from a PRESET group in the same location. If you have edited a patch from a PRESET
group, a number in the USER group will be selected automatically as store destination.
NO
✎