Zoom 8080 - Manual (Page 42)

41 ■
Advanced
Operation
Connect the device in
the
loop of the 8080
(
p. 7).
EXTERNAL
DIST SEND / RETURN jack
1
Activate the Edit
mode and select
"EXT" (external
distortion) as the
effect type of the DIST
module.
2
If required, set the
"BST" (booster type),
"SND" (send level),
and "LVL" (signal level
for next module)
parameters.
3
Store the patch as
required. When this patch is selected, the
external effect device in the
EXTERNAL DIST SEND/RETURN
loop of the 8080 can be used.
4
EXT BST=OFF SND=off
LVL= 1 ZNR=off
Controlling an external effect device
MODEL 8080 ZOOM CORPORATION
MADE IN JAPAN/FABRIQUE AU JAPON
Super
SERIAL NO.
INPUT GAIN INPUT H M L +4dB –20dB
OUTPUT PHONES R L/MONO
EXT
CTRL OUT +4dB –20dB
DC9V1.0A POWER MIDI OUT
SEND RETURN EXTERNAL DIST
SEND RETURN
EXTERNAL DIST
1
EXTERNAL DIST SEND / RETURN jack
Leave the external effect device always turned on and perform simulated on/off switching at the 8080.
When an external effect is selected, but nothing is connected to the RETURN jack, the sound will not be interrupted, because the 8080
internally sends the signal to the next module. However, the EXT module parameters settings will be active, so that the sound may be different
from the sound with the SND parameter set to "off".
NO
✎
NO
✎
This section explains how to use the 8080 for controlling an external effect device or amplifier, and how to use
the Initialize mode to reset the 8080 to the factory default condition.
Other Functions