Zoom 8080 - Manual (Page 38)

37 ■
Advanced
Operation
Use 2-4 to
select effect modules
for 1-3.
Foot switches
Data entry knobs 4
Press the
once more to call up
the page shown
below.
This is the page for selecting the
effect modules to be assigned to
foot switches 4 and 5.
UTILITY/PAGE key 5
Use 3 and
4 to select effect
modules for
4 and 5. Foot switches
Data entry knobs 6
Fsw ASSIGN:
8 SW4=EF3 SW5=DLY
Press the
two
times.
The Utility mode settings are stored
and the unit returns to the Play
mode.
STORE/EXECUTE key
7
Press the
while
playing the instrument
in Play mode.
This will activate Manual mode, and
the effect modules that can be
switched by foot switches 1-5 are
shown on the display.
USER FUNCTION switch
8
Use the 1-5
to turn the effect
modules on and off,
as desired.
Foot switches 9
You cannot assign the same effect module to several foot switches. Page 35.
If Utility mode settings are not stored, they will remain active only until the unit is next turned off. When turned on again,
the unit reverts to the previous settings. If you wish to keep changes you have made, do not forget to press the
STORE/EXECUTE key twice to perform the store process. Note that any edited patch will also be stored at this time.
NO
✎
NO
✎
01 8080LEAD MANUAL
CMP EP1 DST DLY REV
↑ ↑ ↑ ↑ ↑
SW1 SW2 SW3 SW4 SW5
Fsw ASSIGN: SW1=CMP
7 SW2=EF1 SW3=DST
Fsw ASSIGN: SW1=CMP
8 SW4=DLY SW5=REV
01 8080LEAD LVL=100
AMP ¡VOL ™OFF ßHLD